Design of a single phase AC-AC converter

Design of a single phase AC-AC converter

This thesis report is submitted in partial fulfillment of the requirements for the degree of Bachelor of Science in Electrical and Electronic Engineering, 2012.

Dades bibliogràfiques
Autors principals:	Khan, Md. Imtiaz, Ahad, Abdul, Islam, Kamrul
Altres autors:	Abedin, Amina Hasan
Format:	Thesis
Idioma:	English
Publicat:	BRAC University 2012
Matèries:	Electrical and electronic engineering
Accés en línia:	http://hdl.handle.net/10361/1840

Ítems similars

Design of a single phase switch mode AC-DC Converter
per: Surjo, Md. Rafiqur Rahman, et al.
Publicat: (2012)

Study of AC-DC converter
per: Masud, Ali Tanjim Bin, et al.
Publicat: (2018)

A single phase AC-AC boost converter with improved input power factor and THD
per: Kabir, Md. Ashfanoor, et al.
Publicat: (2016)

AC sine wave generation by using SPWM inverter
per: Islam, Md. Sakibul, et al.
Publicat: (2012)

Three-phase AC-AC Power Converters Based on Matrix Converter Topology
per: SzczeÅ›niak
Publicat: (2013)

Modern power electronics and AC drives /
per: Bose, Bimal K.
Publicat: (2002)

Modern power electronics and AC drives /
per: Bose, Bimal K.
Publicat: (2002)

A single phase buck-boost AC-AC converter with low input current THD and high input power factor
per: Abedin, Amina Hasan, et al.
Publicat: (2016)

Comparative study on DC-DC Converters
per: Tushar, Mehedi Hasan
Publicat: (2012)

True three-phase bidirectional switch based AC-AC Buck-Boost converter topology
per: Tanvir Hossain, Mohammad Rubaiyat, et al.
Publicat: (2016)

Input switched single phase buck and buck-boost AC-DC converter with improved power quality
per: Khan, Mohammed Masum Siraj, et al.
Publicat: (2016)

A single phase SEPIC AC-DC converter with improved power factor and input current THD
per: Hossain, Mohammad Rubaiyat Tanvir, et al.
Publicat: (2018)

Develop and test a method to convert wired systems into wireless systems ( wireless communication)
per: Habib, Farhana, et al.
Publicat: (2011)

Design and analysis of DC-DC PWM converter and DC-AC converter
per: Mazumder, Md Imran Kayesh, et al.
Publicat: (2018)

Ćuk topology based single phase AC-DC converter wih low THD and high power factor
per: Kabir, Md Ashfanoor, et al.
Publicat: (2016)

Short circuit study of a balanced 3 phase system using p-inverse
per: Sabbir, Hasan Muhommod, et al.
Publicat: (2015)

Boost and buck topology based single phase AC-DC converters with low THD and high power factor
per: Kabir, Md Ashfanoor, et al.
Publicat: (2016)

A comparative study of DC/AC pure sine wave inverters
per: Bintu, Nusrat Khan, et al.
Publicat: (2014)

Design a solar clean car
per: Mahfuz, Md. Muntashir Bin, et al.
Publicat: (2012)

Performance and analysis of DC-AC pure sine wave inverter
per: Purification, Paul
Publicat: (2011)

System design of a two wheeler self balanced vehicle
per: Rumi, Sheikh Mohibul Islam, et al.
Publicat: (2014)

Design and implementation of a QPSK demodulator
per: Hasan, Mahabubul, et al.
Publicat: (2011)

Design and simulation of a solar PV system for BRAC University
per: Eshita, Shaika Tamanna, et al.
Publicat: (2011)

Multi swarm optimization for following robot using RF communication
per: Lira, Sirajum Munia, et al.
Publicat: (2015)

System design and circuit implementation of a solar powered car
per: Khatun, Karima, et al.
Publicat: (2014)

Design of a pure sine wave inverter for PV application
per: Sayeed, Nuzhat Noor, et al.
Publicat: (2011)

Design and development of a cost effective urban resedential solar PV system
per: Hasan, Fahim, et al.
Publicat: (2011)

Virtual Mouse: Design and implementation of an accelerometer based wireless mouse
per: Aryan, Arghya Dev Biswas, et al.
Publicat: (2012)

Performance analysis of a MIMO Optical wireless link with space time block code (STBC)
per: Islam, Md. Zahirul
Publicat: (2011)

Designing and empirical realization of horn antennas and waveguides in a 60 GHz wireless system
per: Ayesha, Sk. Laila, et al.
Publicat: (2011)

Design of an often cost affective wind power system for a remote Bangladesh locality
per: Mirza, Rifat, et al.
Publicat: (2011)

Novel approaches to low leakage and area efficient VLSI Design
per: Izma, Tajrian, et al.
Publicat: (2011)

Design of a charge controller circuit with Maximum Power Point Tracker (MPPT) for Photovoltaic system
per: Rahman, Shusmita, et al.
Publicat: (2013)

Design and development of microcontroller based ECG simulator
per: Uzoshi, Khandaker Raska, et al.
Publicat: (2011)

Graphene as a replacement for Si in nano-electronics
per: Khan, Raisa Tamanna
Publicat: (2012)

Design of an efficient energy harvester from ambient vibration
per: Rahman, Tasfia, et al.
Publicat: (2012)

Performance analysis of a DWDM optical transport network with crosstalk
per: Md. Fahmid-ul-Islam, et al.
Publicat: (2010)

Designing of an office appliance system using temperature sensor & micro controller for efficient use of electricity
per: Das, Rajat, et al.
Publicat: (2013)

A multitasking PC based robotic ARM manipulator control system in RT-Linux environment
per: Md. Adnan Al Moshi, et al.
Publicat: (2010)

Designing smart charge controller for the solar battery charging station (SBCS)
per: Ferdausi, Marufa
Publicat: (2013)